Aaron

Magneto Polarity

Most lawnmowers I've seen have the body of the engine as positive and the top of the plug is negative...so opposite of most cars.

The magneto has 2 leads from it.

One is a skinny lead (positive) that goes to the body of the motor.
One lead is fat and (negative) and goes to the top of the plug.

If someone wanted to reverse polarity and do this:

Take skinny wire (positive) and put it to the top of the plug AND
Take fat wire and put that to the body of the engine....
would it be as simple as that to make it run with the engine being the ground?

Hi all, this tread is for applying Luc's spark method specifically to magneto systems.

Here is a touch on magnetos that I got from some old Keely net article:

If that is all one does to the engine, then there is no external energy
inputs, such as a battery. The ignition system on the standard Briggs &
Stratton 3HP lawnmover engine is called a "Magneto Ignition System" (MIS).
The MIS works as follows from start-up (very basic):

(a) The manual starter cord is pulled
causing the flywheel (with magnets
mounted on it) to turn.

(b) The flywheel then causes the crankshaft,
camshaft, and piston to which is
connected, to move, as well as causing
the magnets to pass by the ignition
coil, which induce a current and thus
voltage to flow through the coil.

(c) (when point(s) are closed)
As the flywheel magnet passes by the
ignition coil, the magnet in motion
creates an electric current in the
primary circuit, which is completed
to ground at both ends because the
crankshaft lobe has allowed the
moveable breaker points to close.

(d) (when point(s) are opened)
The flywhell magnet has passed by.
The crankshaft lobe opens the breaker
points, causing the electromagnetically
charged field of the primary circuit
to collapse upon the secondary circuit.
This results in high-voltage current to
the spark plug- the terminal of the
secondary circuit.

single wire transmission to charge capacitor

Hi Maxwell,

The main circuit is proprietary right now. The discovery of some of its effects were my own discovery.

The spark plug is being used as a wastegate (turbo pressure relief valve on the exhaust side)...for the purpose of sharpening the gradient of the radiant spikes.

I'll post a better vid with a better demo on normal caps people are used to so that they can see there is real power in the cap.

YouTube - Single Wire Capacitor Charge
Just a quick demo

can't post?

Good idea, I get bombarded too.
However, that is why I bump up this thread, usually get asked about not posting and not seeing energy forum from same people:


If anyone does ask you, simply send them an email telling them to email info @ esmhome.org for approval.

Jetijs, spark the plug like this

Jetijs,

Power the spark plug with this circuit:
YouTube - Water Sparkplug | Electroradiant Event

You may be able to power it by water.

Bourke Engine

Hi David,

I felt for a long time that this engine with Firestorm plugs could probably run on pure hho...even smaller amounts produced by the boosters.

Here are a few posts in regards to a solenoid motor using this system:






For anyone who hasn't seen the concept running on a Bourke Engine, this animated graphic from one of David's websites shows it very well...the links are in his signature of the first message that he started this thread with.


[IMG]file:///C:/DOCUME%7E1/WHITED%7E1/LOCALS%7E1/Temp/moz-screenshot-2.jpg[/IMG][IMG]file:///C:/DOCUME%7E1/WHITED%7E1/LOCALS%7E1/Temp/moz-screenshot-3.jpg[/IMG]

nitrogen effects

Hi Rick,

I have a massive compilation about electromechanical batteries and most of it is not available publicly online. If I can find it in the near future, I'll upload it.

For the golden light effect, I'm not ready to do an experiment with any of it yet. I'm really working on getting it through my head the purpose in that particular setup.

I was reminded last night of a reference in the book Secrets of Cold War Technology by Gerry Vassilatos....VERY RECOMMENDED...CHAPTER 1 ON TESLA! Reference in there is about Tesla mentioning that the ULTIMATE spark gap quencher is sealed with magnets and filled with nitrogen. The nitrogen sucks the electrons away so there is pure aetheric flow.

If it soaks up electrons, that adds another variable.

But, when the nitrogen is in its active glowing state is it possible it is donating electrons in its highly energetic state? Maybe there is free current obtained from that gas in that state?

It makes sense that it would be cooler as any of these systems that would be over 1.0 cop should have some negentropic effects like cooling. Maybe the gas itself is acting as a capacitor to store charge and release it over time?

golden swirling light

The reason I am posting this thread on allotropic nitrogen \ active nitrogen, I can't mention at this point.

There is a device that has golden swirling light inside as the shaft with rotors is spinning up to very high speeds...the light gets more intense the faster it goes. It isn't just for show, but it seems that there is some extracted energy from this into the electrical circuits to keep it going.

The plastic cylinder that the shaft/rotors are sealed inside appears to be filled with nitrogen as 'possibly evidenced' by the swirling golden light inside.

The most sense I have been able to make out of it is that it is nitrogen and is possibly operating as Marinov's SAP - self accelerating plasma tube.
Please see this post for it:


Make sure to look at this diagram on that page:
Ionising gas in donut tube-"x"

and appears to be a hybrid with an electromechanical battery:

using a passive magnetic bearing system like the Halbach Array
and can get to well over 100,000 rpm while self running.

Any comments?

Active Nitrogen is "made" when high voltage is exposed to almost pure nitrogen with an almost non-existent amount of oxygen or other gases. The nitrogen with glow with a GOLDEN color. This was discovered by Lord Rayleigh.

Please see this for more info:
Lateral Science - Strutt`s Allotropic Nitrogen

LORD RAYLEIGH`S
ACTIVE NITROGEN
"What of nitrogen? Is not it`s apparent great simplicity of action all a sham?" Michael Faraday

In 1910 R.J.Strutt (Lord Rayleigh) discovered that an electrical discharge in nitrogen gas produced "active nitrogen", an allotrope considered to be monatomic. The "whirling cloud of brilliant yellow light" produced by his apparatus reacted with quicksilver to produce explosive mercury nitride.
From Modern Inorganic Chemistry, J.W.Mellor 1934 --





From A Text-Book of Inorganic Chemistry, J.R.Partington 1946 --

jeweler made plug?

It looks like a pic I saw that was a prototype of Krupas supposedly hand crafted by a jeweler.

h wave

TheDude,

Lee posted a link to a video that will show you the h wave.
The link is posted in the Bedini SG thread here.

I'm not sure if I posted about this plug, but this might be the other plug I was thinking about...just another concept.

Spark plugs for automobiles small engines and sports craft

hv details?

Hi Chip,

What HV cap are you using? What are you charging it with?

leads

In addition to short leads, use straight lines and 90 degree turns in the wiring for optimum...that is how the radiant likes to travel.

pulsing on negative

Thanks Ash,

The battery powers a load a little longer charged this way compared to the forward way.

Since the Bearden/Bedini Free Energy Generation book came out, I'm surprised I don't see any vids or much discussion comparing the pos way or the reverse neg way.

Here is the vid I posted to show the concept:
YouTube - Bedini Negative Energy SG capacitor discharge

The coils on that energizer are very small...but some people wonder how to pulse on neg with the SSG...you can't I don't think so you have to charge a cap or cap bank with the pos pulse from the diode...then take the cap bank and discharge the neg reversed way to a batt.

Where I really got incredible results with this is using a trifilar oscillator of 2000 turns and the 3rd isolated winding through a bridge charged the cap bank and the circuit pulsed it on the neg side to the batts...that really was quite a difference from discharging cap bank on the + to +.

If using DC impulses to wfc's, my preference is to do the same..pulse on the neg...that way the pos potential from the input power source is already sitting in the water and doesn't have to move into it.

Anyway, Xogen showed doing this in one circuit I replicated about 5 years ago but I don't think they really knew what they were doing with it...maybe they did.

Robert Krupa Firestorm Patent





Read this article:
NEXUS: Firestorm Sparkplug

Patent number: 5936332
Filing date: Jul 21, 1997
Issue date: Aug 10, 1999
Inventors: Robert Krupa, Chester C. Lulavage
Assignee: Century Development International Ltd

&

Patent number: 6060822
Filing date: Aug 18, 1998
Issue date: May 9, 2000
Inventors: Robert Krupa, Chester C. Lulavage
Assignee: Century Development International Ltd.

Abstract
A very unique universal bi-directional firing spark plug for any spark ignited internal combustion engine, whether racing, industrial, truck, aeronautical, automotive, recreational or residential (for trimmers, edgers, brush cutters, leaf blowers, leaf vacuums, chain saws, augers, tillers, lawnmowers, riding mowers, tractors, generators, etc.). This spark plug eliminates misfire and improves gas mileage, peaks engine performance, horsepower, and increases the RPM range, while utilizing and enhancing current ignition systems. In addition, this spark plug serves as a low emission device that reduces the effects of global warming, acid rain, and smog via greatly reduced emissions through vastly improved fuel combustion within all internal combustion engines by operating at a 24:1 air-to-fuel ratio. This unique spark plug is comprised of an elongated or non-elongated body with an electrical connector at one end. An absolute aerodynamic semispherical dome or sphere electrode is secured...

cymatics

Hi Amigo,

Hans Jenny I believe originally used mushroom spores on a stretched drumskin and played a speaker under it aimed at the drumskin playing different tones.

welding the elements

If this is legit and if the rods are what are claimed, a brown's gas welder could probably fuse all of that together very easily. That welder can also fuse a piece of glass around a piece of wood and then some. Just water gas torch using commonly ducted water gas.

plasma

I think the same about the other cells too.

Actually just water alone is exploded on contact with that plasma burst.

Robert Krupa has even ran an engine on 100:1 air/fuel mixture just to prove it could be done. Not for practical driving.

It has always been claimed that a lean mixture can't work but that is only if you're using a measly little spark...that won't release much from the fuel that is there but this big blazing plasma ball will certainly release more from the same amount.