established WFC
Resultant energy state increase is tied to pulse voltage frequency at a given voltage level
The resultant increase in atomic energy state is directly related to the applied pulse voltage frequency at a predetermined voltage level.
Bench
Engineering notebook
422 published findings from the ongoing work — what has been established, calculated and observed at the bench, each traceable to the session that produced it.
-
-
established WFC
Repetitive voltage pulsing raises hydrogen electron to a higher energy state
Repetitive pulsing of the applied voltage fields (66/67) oscillates the Energy Aperture (7) to emit a greater amount of Universal Energy (9a...9n) into the proton nucleus, increasing the hydrogen atom...
-
established WFC
Energy Aperture emits discrete Universal Energy into proton after each pulse's off-time
Once the applied voltage pulse of opposite polarity (66/67) terminates during pulse off-time, the Energy Aperture (7) automatically adjusts to maintain a given energy level, with each aperture oscilla...
-
established WFC
Energy Aperture size responds directly to applied voltage amplitude
An increase or decrease in Electrical Pressure (4/5) causes the Energy Aperture (7) to enlarge or become smaller in direct correspondence to the applied voltage amplitude (Vo...Vn).
-
established WFC
Electrical tension magnitude is directly proportional to applied voltage amplitude
The resultant Electrical Tension of Forces (4/5) is directly related to the Voltage Intensity of the applied voltage fields (66/67), which varies with applied voltage amplitude (Vo...Vn); increasing v...
-
established WFC confidence 0.80
Electron orbital elongation superimposes electrical tension on proton attraction forces
The changing time-share rate of the elongated orbiting electron applies and superimposes electrical tension (4) onto the opposite attraction force (AA') between the electron and proton, which in turn...
-
established WFC
Opposite voltage fields deflect hydrogen electron and proton in opposite directions
Applied voltage fields (66-E1/67-E2) form opposite attraction forces (ST-ST' and RU-RU') across the hydrogen atom: the negatively charged electron is attracted toward the stationary positive voltage f...
-
established WFC
Free hydrogen/oxygen/gases in water bath receive pulse-voltage stimulation post-dissociation
After the Water Molecule separates into component gases via the Electrical Polarization Process, the liberated hydrogen, oxygen, and dissolved air gases remain submerged in the water bath and are furt...
-
established WFC
Balanced phasing prevents atom displacement during Snapping-Action on water molecules
Non-voltage shift (Balanced Phasing of opposite Voltage Potential) helps prevent atom displacement during 'Snapping-Action', by which Resonant Electrical Stress of opposite electrical polarity (RU/RU'...
-
established WFC
'Resonant Action' is voltage tickling of State Space via resonant electrical stress without current draw, tuned to water's dielectric properties
Voltage Tickling of State Space under 'Resonant Electrical Stress' without amp (current) influxing, while tuning-in to the dielectric properties of water, is referred to as 'Resonant Action,' illustra...
-
established WFC confidence 0.80
Greater atomic interaction occurs by extending Arc Line length and raising Voltage Peak-Potential
In terms of Particle Oscillation as an Energy-Generator, if the Voltage Arc Line (Val) length is extended while the Voltage Amplitude is adjusted to a higher Voltage Peak-Potential (Vpp), greater atom...
-
established WFC
Four-stage sequence for water dissociation via Dynamic Voltage Potential Wave-form
The process sequence is: Electrical Polarization Process (elongating the water molecule, changing covalent electron time-share rate, switching off the covalent bond by attenuating electromagnetic fiel...
-
established WFC
Atomic Snapping Action repetition-rate determines energy level of Static Electrical Charging Effect
The repetition-rate of 'Atomic Snapping Action' (Asa) — the number of Voltage Pulse Fields (Vpf) occurring per unit of space-time — directly determines the resultant energy level of the Static Electri...
-
established WFC
Clipped Unipolar Pulse Train increases atomic dwell-time to raise Atomic Energy Level before Snapping-Action
The Clipped Unipolar Pulse Train (Figure 780C) is used to encourage further increase in atomic dwell-time, raising the Atomic Energy Level (AEI) of the Water Atoms to a higher energy-state before Snap...
-
established WFC
Crossover Unipolar Pulse Train used for higher-magnitude continuous stress vs Planar Pulse Train
The Crossover Unipolar Pulse Train (Figure 780B) is used when particle oscillation of the water molecule atoms is to be continually electrically stressed under changing conditions of higher magnitude...
-
established WFC
Opposite electrical attraction force forms across water capacitor during voltage-wave formation
During electrical-formation of each opposite Electrical Voltage-Wave, opposite electrical attraction force (RR'-SS') is produced across the water cap (Cp), setting up the conditions of 'State Space.'
-
established WFC
Incoming pulse signal is electrically linked to a Water-Gap Capacitor with water dielectric
The incoming gated voltage pulse signal (49a...49n) is electrically linked with the Water-Gap Capacitor (Cp) of Figure 7-8, which has a dielectric liquid of water (85) between its plates.
-
established WFC
Maintaining voltage amplitude across water-gap without arc-over enables Hydrogen Fracturing
By maintaining voltage amplitude potential (Vo-64a-64b-64c-Vn) without appreciable amp arc-over across the Water-Gap, the pulsating opposite electrical attraction forces (RR'/SS') electrically charge...
-
established WFC
Water dielectric constant given as approximately 78.54
The water bath (85) is described as a dielectric liquid with a value of typically 78.54 (dielectric constant), which does not like to transfer or exchange electrons, keeping the electrical transmissio...
-
established WFC confidence 0.80
Voltage Coefficient of Water and stainless steel establish the Traveling Electrical Voltage Wave-Guide
The Voltage Coefficient of Water (e/Eo, Eq 21) together with the Voltage Coefficient of the stainless steel material forming voltage surfaces (E9/E10) establishes the Traveling Electrical Voltage Wave...
-
established WFC
Water surface tension aids voltage transmission without altering dielectric value
The surface tension of water adjacent to both voltage surfaces (E9/E10) aids transmission of voltage potential, and the Electrical Charging Effect does not change or alter the dielectric value of wate...
-
established WFC
Stainless steel T304 tube surfaces conduct voltage via skin effect to form the wave-guide shape
Stainless steel material (T304) forming voltage surfaces (E9/E10) electrically conducts and transfers voltage pulse-frequency potential along the inside surface area via skin effect; this chemically i...
-
established WFC
Water bath in space-gap exposed to unipolar pulse-oscillation of opposite polarity
The space-gap exposes the injected water bath (85) to unipolar pulse-oscillation of high voltage intensity of opposite polarity (E10/E9), which propagates opposite electrical attraction force (RR'/SS'...
-
established WFC
Voltage wave-guide formed by two parallel s/s tube surfaces with space-gap between
The tubular Traveling Voltage Wave-guide is physically formed when positive voltage surface (E9) and negative voltage surface (E10) are placed in parallel space relationship about a cylindrical axis o...
-
established WFC
'Resonant Action' defined as voltage tickling of State Space under resonant electrical stress without amperage, tuned to water's dielectric properties
Voltage Tickling of State Space under 'Resonant Electrical Stress,' performed without amperage (current) influx while tuning-in to the dielectric properties of water, is referred to in the WFC Tech-ma...
-
established WFC
Combustible gas atoms of water are electrically stressed under varying pressure to trigger ignition beyond equilibrium
In each State Space condition, the combustible gas atoms of water are 'Electrically Stressed' under different pressure levels to bring on the triggering point for thermally igniting the combustible ga...
-
established WFC
Management system uses a phase lock loop to track and maintain the fuel cell's resonant frequency
When used with a water fuel cell per Letters Patent No. 4,936,961, the preferred management system includes a pulse generator for fuel gas production and a phase lock loop circuit that detects and sca...
-
established WFC
WFC fuel gas maintains optimum 2:1 hydrogen-to-oxygen ratio intrinsically
The fuel gas mixture produced by the water fuel cell intrinsically includes the optimum 2:1 ratio of hydrogen to oxygen, per Stan Meyer's Letters Patent No. 4,936,961 process.
-
established WFC
Larger resonant cavities with higher water conversion rates require pulsing frequencies up to 50 kHz and above
Shape and size of the resonant cavity (as described in US 4,936,961) may vary; larger cavities and higher rates of water conversion require higher operating frequencies, up to 50 kHz and above, with t...
-
established WFC
Gas pressure regulator maintains 15 psi back pressure at fuel cell exit orifice
The gas pressure regulator 13, located proximate the exit orifice of the water fuel cell, maintains a consistent back pressure, optimally 15 psi in the preferred embodiment, in the fuel delivery syste...