gas-mixture

…njecting and intermixing an Non-Combustible Gas (D) (non-burnable gas) with the 'Burnable Gas-Mixture (B) "changes" or "alters" the gas-mixture "Burn-Rate". Increasing the volume-amount of Non-Combustible Gas (D…

…additional non-combustible gases (99a xxx 99n) (supplied via ambient air 101) is added to gas-mixture (88) by way of gas ignition process (98) occurring inside internal combustion engine (55) piston cylinder (10…

…88), metered exhaust gases (99), and metered sub-critical gas atoms (104a xxx 104n) forms gas-mixture (103) entering engine cylinder (102), as illustrated in (240) of Figure (3-31) as to (340) of Figure (3-38).…

…other water molecules (85a xxx 85n) which, in turns, forms hydrogen (86) and oxygen (87) gas-mixture (88) of Figure (3-24). Dissociation of water molecule (85) by way of voltage stimulation (65) is herein calle…

…jecting and Intermixing an Non- Combustible Gas (d) (non-burnable gas) with the "Burnable Gas-Mixture (b) "changes" or "alters" the gas-mixture "Burn-Rate". Increasing the volume-amount of Non-Combustible Gas (d…

…directly retrofitted to the car engine without engine-change since the patented Hydrogen Gas-Mixture co-equals the burn-rate of Alcohol (from 325cm/sec. to 44 cm/sec.), as illustrated in Figure 4 as to Figure 5…

…ent Air, as illustrated in Figure (2-1). Spark-Igniter (A) causes and starts the Burnable Gas-Mixture (B) to undergo Gas-Ignition which, in turns, supports and allows Gas Combustion to take place ... forming and…

…d by way of voltage stimulation (Electrical Polarization Process) ... producing a uniform gas-mixture (B/D) regardless of the Gas Flow-Rate of the Fuel-Cell ... producing a uniform gas-mixture (B/D) only when ne…

…tivation point (E9d) thermally ignites (atomic agitation) the "Energy-Primed" combustible gas-mixture (520) of Figure (5-3) as to (100) of Figure (4-8) by "electrostatic discharge" while being subjected to ever…

…rated gases by way of electron ejection (230) , and thermally ignites ionized combustible gas-mixture under "Electrostatic Pressure" that directly attenuates Energy Apertures (7a xxx 7n) (520) .... releasing the…

…n of the Fuel-Cell gases. The overlapping Flame-Pattern re-ignites the expelling hydrogen gas-mixture (B/D) should Flame-Out occur. Ceramic material is used to form the "Quenching Disc" to "prevent" hole-size en…

…ith an Hydrogen Supply Source sets up The Gas Retarding Process ... allowing the Hydrogen Gas-Mixture to be transported safely through existing Gas-Grid System.…

Injecting and intermixing a Non-Combustible Gas (D) with the Burnable Gas-Mixture (B) changes or alters the gas-mixture's burn-rate.…

…ure' that directly attenuates the Energy Apertures (7a-7n) (520), the ionized combustible gas-mixture is thermally ignited, releasing thermal explosive energy (gtnt) beyond normal gas burning levels on demand.…

Spark-Igniter (A) causes and starts the Burnable Gas-Mixture (B) to undergo Gas-Ignition, which supports and allows Gas Combustion to take place, forming and sustaining a Gas-Flame.…

The Gas-Ignition Process was performed several times per gas-mixture to establish the 'average' Burn-Rate of the Fuel-Gases, which in turn determines the length of the vertical bars in Graph (2-2).…

…he volume-amount of Non-Combustible Gas (D) diminishes and/or lowers the burn-rate of the Gas-Mixture (B/D) still further.…

The Water Fuel Cell produces a uniform gas-mixture (B/D, browns gas/detonation gas) regardless of the gas flow-rate of the Fuel-Cell, and only when needed.…

…s with an Hydrogen Supply Source sets up The Gas Retarding Process, allowing the Hydrogen Gas-Mixture to be transported safely through the existing Gas-Grid System.…

…stage occurs and Gas Ionization Process takes place; at E9d the energy-primed combustible gas-mixture is thermally ignited via electrostatic discharge under increasing electrostatic pressure.…

…separate additional water molecules (85a...85n), forming a hydrogen (86) and oxygen (87) gas-mixture (88).…

…dditional non-combustible gases (99a...99n), supplied via ambient air (101), are added to gas-mixture (88) during gas ignition process (98) occurring inside internal combustion engine (55) piston cylinder (102).…

…or port (36), combining with metered fuel-gas (88) and metered exhaust gases (99) to form gas-mixture (103) entering the engine cylinder (102).…

…rectly retrofitted to the car engine without engine-change, because the patented Hydrogen Gas-Mixture matches the burn-rate of Alcohol, dropping from 325 cm/sec to 44 cm/sec, as illustrated in Figure 4 vs Figure…

…d by the water intermix with the liberated hydrogen and oxygen gases to form the hydrogen gas-mixture that burns at 44 cm/sec.…

The hydrogen gas-mixture burn-rate remains constant regardless of gas flow-rate since water acts and performs as a Gas-Mixing Regulator.…

The overlapping Flame-Pattern re-ignites the expelling hydrogen gas-mixture (B/D) should Flame-Out occur.…

…r system to eliminate gasses and other present substances. Thereafter the non-combustible gas-mixture is cooled, filtered for impurity removal, and mechanically mixed with a predetermined amount of hydrogen gas.…

…ocity and temperature of the hydrogen gas and to adjust the burn-rate of the hydrogen/air gas-mixture to co-equal the burn rate of fossile fuels to obtain, sustain and maintain an open-air hydrogen/oxygen flame…

…ystem to eliminate gasses and other pre- ‘sent substances. Thereafter the non-combustible gas-mixture is cooled, filtered for impurity removal, and mechanically mixed ‘iwith a pre-determined amount of hydrogen g…

…r system to eliminate gasses and other present substances. Thereafter the non-combustible gas-mixture is cooled, filtered for impurity removal, and mechanically mixed with a pre-determined amount of hydrogen gas…

…r system to eliminate gasses and other present substances. Thereafter the non-combustible gas-mixture is cooled, filtered for impurity removal, and mechanically mixed with a pre-determined amount of hydrogen gas…

…er system to eliminate gases and other present substances. Thereafter the non-combustible gas-mixture is cooled, filtered for impurity removal, and mechanically mixed with a predetermined amount of hydrogen gas.…

…r system to eliminate gases and other present substances. Thereafter, the non-combustible gas-mixture is cooled, filtered for impurity removal, and mechanically mixed with a predetermined amount of hydrogen gas.…

…r system to eliminate gases and other substances present. Thereafter, the non-combustible gas-mixture is cooled, filtered for impurity removal, and mechanically mixed with a pre-determined amount of hydrogen gas…

…r system to eliminate gasses and other present substances. Thereafter the non-combustible gas-mixture is cooled, filtered 30 for impurity removal, and mechanically mixed with a pre-determined amount of hydrogen…