Photo0066 gallery

Started by unknown · 21 February 2011 · 1 post

1. jim miller

   #1 · 21 Feb 2011

   Most of the photgrammetric imagery and enhanced images are still in jim miller project thread here at ionizationx
    
    
   Image 1  Use of sharpen, edge enhancement and color reversal to get better edge line for photogrammetry
    
   Image 2 the key ratio  image photo of photo0066.jpg  showing ratio link to photo0068.jpg and caliper measures
   
   449:75:: <val>: 0.75
   4.49 inches
   
   Image 3 - A view of the tube holder bracket with screen caliper measures
   
   613:104::<val>: 0.75
   4.42 inches
   
   Thus, there is a very good consistency between photogrammetric measures of photo0066.jpg and
   photo0068.jpg and the information so graciously provided by Dynodon!!
   
   Assuming a close but not too tight fit for the Cell housing, Dynodon's measurments fo 5.5 OD for
   the cell housing  (minus 2X .375 for cell wall thickness) = 4.75 are right. About  0.13 inch clearance
   which would allow for close O ring fit  and a close (but not jam fit )for the upper tube holder.
    
   Actually the figures are better than that!  4.75"-4.49"= .26"    .26/2 = .130 which is sooo close to .125  1/8th inch for O ring  Almost  like it was planned that way!

   attachment_6716 attachment_6719 attachment_6720 PICT0066-23.jpg Photo0066.TOSCALE.jpg Phoo0066DIAM.jpg