Skip to content
Stan’s Legacy

Marpacifico

3 posts

An identity on IonizationX as it was harvested, not an account on this site. Nobody here has claimed it, and nothing connects it to a person by name.

Your Design

#25 · date not recorded

Flaghole, the cell your about to build  is pretty close to the one I built
execpt my mesure were slightly higher.

My wall thickness is 1/8 and 36" long  with 8" dia.
Tubes are 1.5" and 1.25" at .064 thickness 27" long.
I used plumber gasket for spacers.

My problem is when connected in // the cell draws around 100 amps no pwm.  straight DC  --  I also get a lot of sluge :(
when connected in series, .8 amp but no production :(

100 amp will burn you generator, it is extremely high.

1. Connect in series.
2. Do not use tap water.
3. Use rain or destiled water and little bit KOH (Vinager), that will increase your 0.8 Amp.
4. Try to use PWM, it is going to help you to establish a suitable frequency. Later, probably, won't use KOH.

Magnet HHO !!!

#4 · date not recorded

I have tried this and yes it is interesting, It does the Magnetron effect similar to that in Microwaves.
electrojolt , how did you test it? Could you send us a sketch?

I think is like this, each parts connect to wire. But HHO came from edge of magnet, then I attached two new pictures.

stevie, what do you think? I do not know if a right in my drawing.

Magnet HHO !!!

#3 · date not recorded

Thats a new form to produce HHO, I've haven't see it. Look good idea.

If you stop video when cable makes contact with "water", you will see immediate production, which means a saturate water of KOH or sea water. And obviously that use more than 30 amps. I make a similar test with my HHO generator.

But, I am going test with magnet. Stevie, how you think it is connected?

Thanks for share the video.