Skip to content
Stan’s Legacy

tachyon

24 posts · 37 more in threads this archive does not carry · writing between Dec 2012 and Jan 2015

An identity on Energetic Forum as it was harvested, not an account on this site. Nobody here has claimed it, and nothing connects it to a person by name.

laser-saser reactor

#14 ·

at least I found out what SASERS are one step closer to virtual reality...

Solar top

#10 ·

I found out about this research .. "Optically-induced charge separation and terahertz emission in unbiased dielectrics" maybe it has something to do with it.

Underwater Steam Jet

#8 ·

you need to have a pressure differential in order for this to work it's the pressure outside of the chamber doing work NOT the implosion if you were to do this inside a vacuum space nothing would happen.

where are you going to put the piston rod? you need to create an air tight space to achieve a vacuum otherwise nothing will happen..or are you going to use a magnetic piston and use some coils to extract energy?

Underwater Steam Jet

#5 ·

When there is a low pressure gradient on the front of the boat by the implosion , the higher pressure on the rear of the boat pushes the boat forward but this is not traditional jet propulsion where there is conservation of momentum acting between the expelled mass and the mass of the vehicle, the pop pop boat you say acts like jet propulsion or like the hose of your garden.

Inspiration

#4 ·

Hi , pure graphene is conductive , graphene oxide isn't conductive until you reduce it. He probably uses reduced GO as the IR absorber.. are there any other transparent IR absorbers? I am interested in this.

Atomic Heart: COP = 300

#15 ·

it's more complex than this.. you need to remove electrons for coulombic forces to collapse

Atomic Heart: COP = 300

#13 ·

tell him to add NaCl around 5 Ph and heat the water until vaporization , the phase shift is probably dependent on the width of the glass and the material you use for the mirror outside of the ball.. for any other questions email.

Thermolysis of water

#12 ·

you can do a Y tube and form a right hand wounded coil in one tube terminal and a left hand wounded coil in the other tube terminal and connect the one coil and to + and the other to -, it will seperate oxygen in one side and hydrogen in the other side..