sebosfato

i have just watched a video from steorn YouTube - 6/6 Addendum to Steorn's Orbo Electromagnetic Interaction COP greater than 1

Question

are they stating that they can multiply the energy by 99x ???

tomorrow they will release the answer to all

We already have this technology too is called ecopower and can be used on gasoline and diesel. Cars, motorcycles and trucks. Is based on transforming big gasoline molecules in acetylene and other gases that can have a more complete combustion. For example if you burn a piece of wood it will not burn completely and will take some time to burn. If you burn the same mass of wood in powder form it will burn completely and quickly. It has good results up to 20% fuel economy in new cars with injection system. Because it regulates the fuel coming in by the level of oxygen coming out and having a more complete burn will result in less oxygen coming in so the injection system automatically injects less fuel maintaining the same original power. In old cars it work too(with carburetor), but the savings in km/l will be less as you will only have more power to use, normally people use also that power ending with a fuel economy less than 15%.

Regards

You can do it with my design pll i guess you just reduce the capacitor of the pll and you must use the 7646 pll instead of the 4046 and you should work at 5 v
You wont need the divider and the feedback.

check my thread stanley meyer the true

I suggest you to read this thread: OUPower.com :: View topic - Magnetic Hydrogen Electrolyzer

hi hms-776 i once had the effect of the steam resonator i was using two tubes but the inside tube had mylar foil rolled around it and when the water started to get between the mylar laminations it instantly became like a geiser steam and steam. i was using a flyback transformer an voltage was about 2000 volts when it started to steam fail hehe
hope that helps

if you want read my posts
peace and look at vic voltage sync pulse circuit this realy works but the coils must be thick wire
tip use multisim 10 to make simulation
you just need to recirculate the current as you said in another post voltage is = to amps x resistance

I believe resonance is used to cause a very high recirculating current enough to start the ionization because of the high voltage developed. It becomes a chain reaction. If you want read my last posts you find here http://www.energeticforum.com/renewa...lained-18.html http://www.energeticforum.com/renewa...lained-19.html ...

This is my vic it works quite well
Your schematic miss one choke and the diode direction i think is wrong

discussion about phase lock loop design by meyer
help Feedback winding for resonance with pll 4046 - Electronic Circuits Projects Diagrams Free