Bench
1,304 published findings from the ongoing work — what has been established, calculated and observed at the bench, each traceable to the session that produced it.
established WFC
The efficiency of the Water Fuel Cell process depends on the tuning frequency of the LC circuit and having this balanced with the mobility of the ions and the spacing between the plates; a relaxation...
established WFC
The Water Fuel Cell circuit is a novel form of electrolysis in that no net current needs to flow around the circuit; while the voltage applied is zero, ionised charges are able to recombine without fl...
established WFC
On the charging side of the Water Fuel Cell circuit, ions are pulled out of the dielectric water and moved toward the metal electrodes; on the discharging side they may go back into solution, and a po...
established WFC
In the Water Fuel Cell, charge from hydrogen and hydroxyl ions builds voltage; the more charge that flows, the more the voltage builds up, and the more ions are pulled out of solution, forming a self-...
established WFC
The Water Fuel Cell circuit has a high frequency of the order of five kilohertz superimposed through the windings of the field coils, and the circuit is half-wave rectified to allow the capacitor to d...
established WFC
The power to the Water Fuel Cell circuit comes from an alternator connected across a stainless steel capacitor with water between its plates; the dielectric water itself provides the charge that charg...
established VIC
Per Appendix B Note 1, Choke-Coil (62, Fig 7-1) magnetic field (FL2) during pulse on-time impedes electron flow (since electron mass is electromagnetic and interacts with magnetic field strength), cau...
established WFC
Using atomic mass units where 1 electron/proton pair ~1 Mu, water's 2 hydrogen atoms (2 Mu) plus 1 oxygen atom (8 Mu) totals 10 Mu, so hydrogen is 2/10 = 20% of the water molecule's mass, yielding 1.6...
established WFC confidence 0.80
The document contrasts the WFC's Electrical Polarization Process (EPP), which achieves high gas yield per unit of electrical power, against prior-art electrolysis using a 20% electrolyte solution unde...
established WFC
Subtracting 11% ambient air (5,126 cc/hr) from the 46,600 cc/hr EPP gas-yield gives 41,474 cc/hr, and applying the 20% hydrogen mass-unit ratio of water yields 8,294.8 cc/hr of hydrogen content, givin...
established WFC
Comparing WFC gas yield (46,666 cc/hr) to an estimated electrolysis gas-yield (27.5 cc/hr, derived from 55W EPP vs 8.8W electrolysis loading), the WFC Differential Efficiency Factor (DEF) is 1,696 tim...
established WFC
The 420,000 cc/hr total gas production rate divided across 9 Tubular Voltage Wave-Guides yields 46,666 cc/hr per tube, with each tube drawing 12.5V x 4.4 amps/hr = 55 watts/hr.
established WFC
The Tubular-Array WFC produced gas at a rate of 7 lbs/min per 1-liter cavity, calculated as 1,000cc x 7lbs/min = 7,000cc/min, or 420,000 cc/hr total gas production rate.
established WFC
The Tubular-Array Water Fuel Cell (E2A) was tested at an electrical power loading of 12.5VDC @ 40 amps = 500 watts.
established WFC
During voltage stimulation testing, the constant and sustained hydrogen gas flame produced was hot enough to melt stainless steel 12 gauge wire material, with flame temperature exceeding 2500 degrees...
established WFC confidence 0.80
A Rotary Pulse-Voltage Alternator test configuration for the hydrogen generation system yielded a gas production rate of 46.6K cc/hr at 12.5 volts.
established WFC confidence 0.80
Testing equipment included a Variable Flat-Plate (Water Fuel Cell) labeled E1A paired with a Solid State Amp Inhibiting Circuit labeled 8XA, measured using a TIF Instruments 1000 DC Digital Clamp-on C...
established WFC
The Electrical Polarization Process (EPP) describes voltage dissociation of the water molecule: an applied voltage creates an electrical attraction force across the gap in tap water, producing gases;...
established WFC
A direct current electrical potential (constant or pulsed) is applied to the non-oxidizing stainless steel 'plates' of the Hydrogen Generator System — described as a voltage with only a minimum curren...
established WFC
The Hydrogen Generator System's non-oxidizing 'plates' are made of stainless steel tubing or other stainless steel configuration, housed in a non-oxidizing clear acrylic plastic material housing for g...
established WFC
The non-chemical hydrogen gas generation system (Hydrogen Generator System, U.S. patent application serial 6/302,807 filed 9/16/1981) was tested and found operable using distilled, rain, lake/reservoi...
established WFC
When immersed in natural water and having a voltage with very low current applied (including with both hydrogen and oxygen atoms present), the 304 stainless steel plates lose very little metal.
established WFC
When immersed in natural water (tap, river, sea, well, or rain) with sodium/potassium content per R&D Laboratory testing, austenitic 304 stainless steel corrodes no more than 0.0007 inches per year; w...
established WFC
Spectrographic chemical analysis of 0.50-inch and 0.750-inch outside diameter tubing samples confirmed a general purpose austenitic type 304 stainless steel, face-centered cubic, paramagnetic, known f...
established WFC
The summary report identifies the device under test as the 'Natural Water Hydrogen Generation System,' corresponding to U.S. Patent S/N 6/302,807 filed Sept. 16, 1981, prepared for patent validation,...
established WFC
Gas samples produced from different water sources were analyzed for volume % oxygen, nitrogen, and hydrogen with corresponding BTU values: river water (24.7% O2, 79.3% N2, 46.0% H2, 140 BTU), city tap...
established WFC
Analysis of water samples (drilled well, tap, rain, lake, ocean, distilled) showed sodium concentrations ranging from <1.0 ppm (distilled) to 25,000 ppm (ocean salt water), and potassium from <1.0 ppm...
established VIC
In Voltage Intensifier Circuit Diagram (AA), a gated variable amplitude pulse train (49a...49n) passes through a blocking diode into Resonant Charging Choke (56, primary) and Resonant Charging Choke (...
established VIC
Pulse-voltage repetition rate sets up a step-up electrical charging effect since the Resonant Cavity functions as a Capacitor (ER) due to the dielectric value of water (78.542), which becomes an integ...
established VIC
The paired coil wires' opposite voltage potentials (positive electrical attraction force B+ = negative electrical attraction force B-, called Electrical Stress SS'=RR' as to (160) of Figure 3-26) are...