shadowfc

Thank you for reply Don!
I'll finish my drawing of whole setup now. I hope it will be closer to Stans work then ever.

Question to all: is it necessary to adjust weights of electrodes to the ratio 2:1? Hydrogen is released in 2 times more than oxygen...

Thanks for the clarification. What can I say, the circuit works beautifully as promised!
Excellent production at .5 amp... more output than 'brute force' electrolysis cells at 10 amps!
I still need to measure the coil inductance - just to be thorough.
Now on to deeper Meyer truths, resonant scanning, steam resonators, etc...

Nice to hear this man! Would you like to share us your results (photos, videos..)? Good luck to your further researching.

Hi!
I have drawn the cell sketch in a cut. At me two question to Dynodon:
1. How the tube concerning a rod should be located?
2. On what depth it is necessary to do drillings in a rod?
Thanks.
(http://www.photoshare.ru/data/73/73838/1/4zymz2-ops.jpg)
(http://www.photoshare.ru/data/73/73838/1/4zynef-q3u.jpg)

Follow this link: http://www.chipdip.ru/product0/44265.aspx (Russian seller of electronic components).
It's just a ferrite plates (20х3х115mm) that I cut and then glued as I have. Very simple task if you have a dremel 
Here is a link to this amazing tools site: http://www.dremeleurope.com

You can made this bobbins using a lathe as i did...

(http://www.photoshare.ru/data/74/74309/1/5cq3cr-ddk.jpg)