kumaran

Would you say the main differences between your alt. set up and boyce's schematics is boyce uses an electrolite such as koh and you use just water?  I've haven't seen any post where you use an electrolite.

Keep it simple. What ever information related to Bob Boyce method uses electrolyte (28% KOH) and what ever information related to Stan Meyer does not use electrolyte (just tap water with little conductive). I'm using Bob Boyce method now.

Hi hydrocars,

I did test the 3PH resonance drive circuit before but didn't measure gas output. I find it's a bit hard to tune the right frequency in three phases and ended up with blowing mosfets. I will go back to this circuit once I got some free time. I suggest you guys focus along this direction and probably can get results faster since the method already tested by Bob Boyce. There must be some hidden secret Bob never release to public.

If some effort put into this line, I'm confident that you guys can break the rule. Frequency 10.7kHz, 21.4kHz and 42.8kHz. Happy experimenting.