Appendix A: table of tabulations

Page 62

Appendix A

Table of Tabulations

Tab 33) Calculation on using “Mass Unit” to determine the amount of hydrogen contained in a gallon of Water.

Tab 34) Calculation on using “Mass Unit” to determined the amount of hydrogen contained in a gallon of Gasoline.

Tab 35) Calculation on using “Mass Unit” to determined the amount of hydrogen contained in a pound of Natural Gas vs. Water.

Tab 36) Calculation on using “Water as Fuel” to run a 50 hp I.C. Engine as compared to Gasoline.

Tab 37) Calculation on determining the liquid-volume of a “Water Droplet” per injection cycle.

Tab 38) Calculation on determining the electrical power input required to electrically energize the Voltage Intensifier Circuit per injection cycle.

Tab 39) Calculation on determining the liquid-volume of a “Water Droplet” required to run a 1000 Bhp I.C. Engine per injection cycle.

Section Appx A

Page 63

RE: Table of Tabulation Appendix A

Application Notes

Water vs. Fossil-Fuel Energy Content

Water is composed of (2) Hydrogen Atoms and (1) Oxygen Atom to form a molecule of Water.

Atomic Mass Unit:

1 Electron (E) = 1 Proton (P) ~ 1Mu

Hydrogen Atom: 1E = 1P ~ 1Mu

Oxygen Atom: 8E = 8P ~ 8Mu

(0) Atomic Mass Ratio (Mur) of Water

** See Appendix (B) Note (2)

Whereby,

Molecular Structure of Water

(Volumetric Displacement of Atom spheres) Thus,

One gallon of Water contains 1.669 lbs.

of Hydrogen

Energy- Yield Potential of Water

One water gallon equals 8.345 lbs

1.669 pounds of hydrogen-fuel of water - .18359 Ibs (11% per volume of impurities ... typically 20 ppm ~ 40 ppm contaminates with Ambient Air being present ) =

1.4854 Ibs of hydrogen atoms available for gas combustion per gallon of Water approximately.

Water as Fuel ®

The by-product of burning gases derived from Water is environmentally safe since there is no carbon atoms present in the Water molecule ... resulting in the re-formation of Water "mist" after gas combustion ... being able to re-energize the newly formed Water Droplets for energy "reuse" once exposed to Sunlight. (See Energy recycling graph 530 of Figure 5-6, once again)

Stanley A. Meyer Appx A 01

Page 64

RE: Table of Tabulation Appendix A

Natural Gas is composed of (5) carbon atoms and (12) hydrogen Atoms to

form a molecule of gas. (Tab 35)

Atomic Mass Unit:

1 Electron (E) = 1 Proton (P) ~ 1 Mu

tT t tT i tT Hydrogen Atom: 1 E=1P~ 1Mu

Carbon Atom: 6 E = 6P ~ 6 Mu

> Cc Cc Cc Cc c ‘G) Atomic Mass Ratio (Mur) of Natural Gas:

** See Appendix (B) Note (2)

Whereby

Molecular Structure Of Natural Gas 12H (Mu) divided by 42 (Mu's) = 28% of (Volumetric Displacement of Atom spheres) gas pound (Ib).

Thus,

One pound (Ib) of Natural Gas contains .28 lb of Hydrogen Atoms

Fuel Gas Contaminates: Cryogenic Processing:

12% Non-burnable Contaminates (carbon dioxide, heavy hydrocarbons, and Water vapor) .28 lbs of hydrogen atoms x 12% =.28 lbs - .033 = .247 lbs Hydrogen atoms Energy- Yield Potential:

.247 lbs hydrogen atoms - 10% (absorption Contaminates) = .247 - .024 = .223 Ibs of hydrogen atoms available for gas combustion per pound of Natural Gas approximately.

Thereby

As to Normal Gas Burning Levels, One pound (1) lb of water contains approx. (.185) lbs of Hydrogen Atoms as compared to One pound (1) lb of Natural Gas which contains approx. (.223) lbs of Hydrogen Atoms. Water, of course, supplies its own oxygen to support the combustion process; whereas, Natural Gas must extract oxygen from air to produce thermal heat.

Energy Enhancement Process:

Energy Yield Enhancement of water is increase beyond Natural Gas burning rate by way of the Hydrogen Fracturing Process which simply prevents and/or retards the formation of the water molecule during thermal gas ignition/combustion... Energy priming the combustible gas atoms by stimulating the Atomic Energy Balance of Water (memo WFC 424) undergoing "Voltage Tickling of State Space" ..to cause "Particle Oscillation" as a "Energy Generator".

Stanley A. Meyer Appx A 03