established WFC
Water dielectric property opposes amp leakage while another property allows electrical charge
The dielectric property of water opposes amp leakage (Re), while another property of water takes on an 'Electrical Charge'.
Bench
Engineering notebook
424 published findings from the ongoing work — what has been established, calculated and observed at the bench, each traceable to the session that produced it.
-
-
established WFC confidence 0.80
Circumference surface points determined from cylindrical diameter using pi
Circumference surface points (E9a - E9n) are determined from the diameter cross section (D) of the cylindrical surface using the mathematical constant (x) = 3.1416 (pi), per Figure 7-11 (720).
-
established WFC confidence 0.80
Surface area of tapered resonant cavity computed from longitudinal length and circumference points
Surface Area (A) of the Resonant Cavity is expressed via longitudinal length (h) of the tapered resonant cavity, exit pan circumference surface point (a = E9d), and cylindrical circumference surface p...
-
established WFC
Capacitance of the water cell is a function of plate area, plate spacing, and water permittivity
Capacitance (Cp) between Electrical Voltage-Plates (E1/E2 - E9/E10) is determined by the surface area (A) of the plates, the distance (d) between plates (in inches), and the permittivity (Eo) of water...
-
established WFC
Water dielectric resistance is 78.54 ohms at 25°C, enabling electrical charge storage
The dielectric property of water (78.54 ohms @ 25°C) permits storage of Electrical Charge when a potential voltage difference exists between Electrical Voltage-Plates (E1/E2 as to E9/E10).
-
established WFC confidence 0.80
Resonant cavity gap-size must be sufficient to allow the Quenching Effect
Each resonant cavity design functions as a Voltage Wave-guide (570) with a gap-size (35) sufficient enough to allow the 'Quenching Effect' to take place, as illustrated in Figure 7-12 (730) and Figure...
-
established WFC
Excitor Plates can be shaped into three resonant cavity geometries for different voltage wave effects
Excitor Plates (E1/E2) can be configured as: linear cylindrical resonant cavity (Tubular Cavity 730A) producing a Traveling Constant Electrical Voltage Wave; taper cylindrical resonant cavity (730B) p...
-
established WFC
Excitor Plates made of Stainless Steel T304, chemically inert to liberated gases
Electrical Voltage-Plates (E1/E2), called Excitor Plates or Voltage Zones, are made of Stainless Steel T304, which does not chemically interact with liberated hydrogen, oxygen, and non-combustible gas...
-
established WFC
WFC water capacitor forms automatically between Excitor Plates with water dielectric
Capacitor (ER) is automatically formed when dielectric liquid water (Re) is placed between Electrical Conducting Plates (E1/E2), per Figure 1-1 (Memo WFC 420).
-
established WFC confidence 0.80
Dielectric gap-spacing (Cp) affects energy yield from water dissociation
Dielectric gap-spacing, denoted (Cp), is one of the parameters (along with voltage amplitude, duty cycle, gated pulse-frequency, and inductor/coil lengths) that determines the thermal explosive energy...
-
established WFC
Thermal Explosive Energy-Yield from water depends on multiple stacked parameters
Thermal Explosive Energy-Yield (gtnt, 16a-16n) instantly produced from water (85) is determined by Voltage Amplitude (Vn), Duty Cycle of Pulse Train (T1-T2a...T1-T2n), Gated Pulse-Frequency of applied...
-
established WFC
WFC capacitor forms when water dielectric is placed between excitor plates under opposite polarity voltage
The Resonant Cavity forms capacitor (ER) when the dielectric liquid of water (85) is placed or injected between electrical conducting plates (E9/E10) while applied voltage Potential of opposite polari...
-
established WFC
Surface Polarity Effect (skin effect) helps maintain water molecule alignment during pulsing
The resultant Surface Polarity Effect (skin effect) (624) supplies a residual atomic Electrical Charge Field that helps maintain molecular alignment of water atoms (617) during pulsing operations.
-
established WFC
Excitor plate molecular alignment persists after pulse off-time to aid next pulse
After the applied voltage forms molecular electrical orientation (625a-625n) in the plate material, this orientation remains in electrical atomic alignment after pulse off-time (T2), aiding transferen...
-
established WFC
Excitor plates are 430 T304 stainless steel that undergo particle alignment under voltage
The stainless steel (s/s) T304 material forming Voltage Zones (E9/E10) undergoes particle alignment of its atomic structure when exposed to applied electrical voltage fields (66/67), producing molecul...
-
established WFC
Applied voltage causes molecular polarization alignment of water molecules
Applied voltage Potential (66/67) causes and sets up Molecular Polarization Alignment (617) via electrical molecular rotation, positioning each water Molecule (85a-85n) under opposite electrical attra...
-
established WFC
Rain water used for WFC has ohmic value of 78.54 ohms
Rain water (85f), being almost free of contaminates due to the Water Evaporation Process, is a resistive liquid having an ohmic value of 78.54 ohms and acts as a liquid-insulator restricting the flow...
-
established WFC
WFC water gap dielectric is natural water with no electrolyte added
The Water Gap (616), which forms the Taper Resonant Cavity, is occupied by a dielectric liquid identified as natural water (85) having no electrolyte added thereto.
-
established WFC
Water's dielectric value (Re) is approximated via Capacitance Equation Eq.22
The dielectric value (Re) of Water Fuel (85) referenced in Eq. 9 is further approximated in the Capacitance Equation (Eq. 22), illustrated as 650 of Figure 7-4, relative to the Tapered Voltage Wave-Gu...
-
established WFC
Opposite-polarity electrical stress triggers instantaneous Hydrogen Fracturing Process
Applied Electrical Stress of opposite voltage polarity (ST-ST' to RU-RU') triggers the Hydrogen Fracturing Process (390 of Figure 3-42) in an instant of time, releasing thermal explosive energy (gtnt,...
-
established WFC
Covalent Switch-Off is a downstream effect of the Electrical Polarization Process
The weakening of the water molecule's covalent bonding occurs while the water molecule structure is being subjected to and undergoing the Electrical Polarization Process, linking EPP directly to the C...
-
established WFC
Reduced nucleus particle spin-velocity weakens covalent bonding of the water molecule
When the Gyroscopic Action of Nucleus Particles is reduced in orbital spin-velocity, it directly weakens the covalent bonding of the water molecule by attenuating the electromagnetic fields of each at...
-
established WFC
Covalent Switch-Off is triggered by opposite electrical stress deflecting orbital electron pathway
Covalent Switch-Off occurs when the deflected and elongated Orbital Electron Pathway reaches a point where applied Opposite Electrical Stress (ST-ST'/RU-RU', A-A'/Z-Z') is sufficient to cause the Gyro...
-
established WFC
Voltage-triggering process activates at maximum voltage deflection point E9d, releasing thermal explosive energy
Once maximum voltage deflection (V0-Va-Vb-Vc-Vn) is achieved at Activation-Point (E9d) of Figure (6-2), the voltage-triggering process (600) releases thermal Explosive Energy (gtnt) from the atomic le...
-
established WFC
Hydrogen Fracturing Process releases atomic energy by preventing water molecule reformation
The Hydrogen Fracturing Process (390) triggers and releases atomic energy from natural water (85) by retarding and preventing reformation of the water molecule while it is subjected to a sub-critical...
-
established WFC
Combined actions produce hydrogen and oxygen in geometrical progression via the Hydrogen Fracturing Process
Resonant Action (21), Compounding Action (22), Laser Injection (17), and Energy Pumping Action (520) together allow production of hydrogen and oxygen gases from water in geometrical progression, setti...
-
established WFC
Compounding Action superimposes particle impact onto the Electrical Polarization Process
Compounding Action (deflection of electrical charged particles), driven by voltage stimulation, aids Resonant Action by superimposing particle impact onto the Electrical Polarization Process (item 160...
-
established WFC
Applied voltage amplitude is independent of resonance frequency and controls ionization
Applied voltage amplitude (Vo to Vn) is independent of Resonance Frequency and is adjusted to cause water bath atoms to momentarily enter a liquid-to-gas ionization state, ejecting negatively charged...
-
established WFC confidence 0.80
Hydrogen Fracturing Process releases atomic energy by retarding water molecule reformation
The Hydrogen Fracturing Process triggers and releases atomic energy from natural water by retarding and slowing down the reformation of the water molecule while it is subjected to a sub-critical state...
-
established WFC confidence 0.80
Opposite attraction force provides energy transfer path to protons during nucleus grouping
The opposite attraction force (BB') provides an energy transfer path (12) to each respective proton from the Energy Aperture (11), which is centrally formed during proton grouping that establishes the...